Questions about Paper

[Mrs.Panda]

I'm new to invitations. I want to make my own, however I'm not sure what paper I am supposed to use, or where to buy it.
I know that I want my invitations to be the consistency of a greeting card, however I do intend to layer them.
I'm really lost here, and need some serious tutoring!
I would like a base layer, and a smaller sheet on top of that (contrasting colors) and I want to tie ribbon to the side.
This is the look I am going for:

http://i27.tinypic.com/2ujrp7c.jpg

[jillifer22]

I went to marcopaper.com. They have all colors and weight.

[WebLady]

You can buy paper all over the internet, or you can look in local craft type stores like Michael's or Hobby Lobby, or even office supply stores will sometimes have card stock. You could even check Walmart and Target; or a local school supply store maybe.

Here is a chart I found that might help you figure out the whole weight thing ...

Translucent Vellum paper - 17 lb
Standard Copy Paper - 20 lb
Linen Paper (common in resumes) - 70 lb
Index Cards - 110 lb
Linen Card Stock - 80 lb
High Quality stationery - 100 lb

[Mrs.Panda]

Thanks guys! I'm off to a pretty good start... I'll post a mock-up when it's ready! :D

[Brian's Bride]

That is so cute! I got my paper from www.paperandmore (http://www.paperandmore). Loved them!

[DIYinvitations]

Kiki, you can create almost the exact same design pretty easily.
Use a cardstock weight of paper for the greeting card consistency you are talking about. You can find them in many different colors at an arts and crafts supply store. You can also check office supply stores like Staples and Office max. A 65 lb. weight of paper should be adequate.
The paper you will layer underneath does not have to be as heavy of a weight. I would recommend a 100% cotton paper stationery.
Other tools that would be beneficial are a large circular paper punch for the cut out where the letter "M" shows through, and maybe a smaller punch for punching slats for the ribbon to slip through.

First cut your cardstock in half the long way and fold the left edge over. If you use a cardstock heavier than 65 lbs you might have to score it. Print onto the stationery and then cut it in half. If it is easier for you, then you can even cut the paper before you print onto it.
Punch the hole into the left side fold so the lettering shows through. If this seems like a lot of trouble you could skip the whole punching and simply use a really nice rubber stamp, or some dried flowers to embellish the edge.
Punch holes to tie your ribbon through and viola!

If you need any more help let me know, you can email me through my website or just go there for some inspiration. The website is on my profile!